Features Hub

Why power protection is about more than just the UPS

Thu 10 Sep 2020 | Louis McGarry

Power protection is not just about the UPS, it’s about your plan should there be a power outage, writes Louis McGarry, sales and marketing director at CENTIEL UK Ltd, explains

It’s hard to get overall statistics for the number of UK power outages each year but as I write, the UK Power Network has reported 11 unplanned outages across the nation this morning so far…

A UPS system protects data centres from such incidents and also evens out interruptions such as dips and surges to supply clean continuous power.  However, power protection is not just about the UPS, it’s about your plan should there be a power outage. It’s about understanding how all of your critical power infrastructure works together to protect your load, and how one change could impact everything else.

In August 2019, the UK suffered a significant power outage when two power stations became disconnected from the grid. Nearly 1 million people lost power and there were reports of transport chaos affecting both England and Wales.

However, the story that sticks in my mind is of a hospital in Ipswich, where the back-up generator failed to start due to a faulty battery. The knock-on effect of a power outage can have far-reaching consequences and so the decisions made when developing a power protection plan are critically important.

Essential planning

So often we are presented with simply the power requirement, resilience level and autonomy required to supply a quote. At the same time, we are asked to minimise the budget.

However, being involved earlier, at the design stage of the plan can be of real value for data centres. Integrating a UPS system is governed by the rating and load type, whether there is long term secondary back-up (i.e generators) and the available space, which all determines the autonomy. Generally, when generators are part of the infrastructure, the UPS is used as a bridge to hold the load until the point at which the generator is up and running.

So when is the right time for the UPS to hand the load over to generator?

If the plan is carefully thought through, protection can be maximised while costs are minimised. Take these two scenarios: number one, during mains failure do you wait for five minutes before transferring to generator in the hope that mains power returns, avoiding a four pole transfer?

Number two, in the event that the generator doesn’t start during mains failure and the UPS is left holding the load, how long would it take to complete a graceful shut down

Ideally, you don’t want to deplete the batteries completely as then they will not be  available when the grid returns, however, sometimes this is unavoidable, so this needs to be added into the autonomy calculation.

Transferring to generator involves a short break in power and therefore a risk, so would it be better to use the UPS and batteries for longer than five minutes to see if the grid returns to full function? If so, a longer autonomy and more batteries are needed.

These decisions are very individual depending on the nature of the critical load being protected and so the whole plan needs to be tailored accordingly but based on informed decision making.

Make sure you devise a plan at the outset that ensures you have the optimal power protection for your data centre. Otherwise, a simple oversight in the planning process can have the butterfly effect, resulting in a significantly different and unfavourable outcome further down the line.

Experts featured:

Louis McGarry

Sales and Marketing Director
Centiel UK Ltd


power ups
Send us a correction Send us a news tip